Pure Water Products Refrigerator Connection Kit

Easy Installation Instructions for Connecting Your Undersink Water Filter or Reverse Osmosis Unit to Your Refrigerator.

After you've run your tubing and have it roughly in place,

1. Turn off the water filtration unit and open the ledge faucet to relieve pressure.

2. At a convenient place, cut the 1/4" tube going to the unit's ledge faucet and insert the John Guest 1/4" tee into the faucet tube. Follow enclosed John Guest instructions.

3. Connect the tube going to the refrigerator into the empty port of the tee.

4. If you have an inline shutoff valve (some kits have it, some don't), cut the tube going to the refrigerator a few inches from the tee and insert the inline valve into the refrigerator tube. The water can flow in either direction through the tee, so there's no "IN" or "OUT."

5. On the refrigerator end, remove the current water inlet tube (if any) from the back of the refrigerator and replace it with the John Guest refrigerator connector. Just get it snug. You probably won't need a wrench.

6. Connect the new refrigerator feed tube by pushing it into the refrigerator connector you have just installed.

7. Turn on the water filter, open the inline valve to send water to the refrigerator, and check for leaks.

If you have a question, please call